31
- The surface area is sum of the walls surface.
WARNING:
Make sure the appliance cannot get wet. Protect from water and rain.
1. Turn the regulation knob on the gas container into the open position.
2. Release the knob and turn it to the position corresponding with the desired
amount of heat.
3. Open the water tap.
4. The product is now ready to use.
5. See fig, 1: control panel.
M = Turn on the appliance with button M
B = more / less heat/gas
H = more / less water flow
WARNING:
The water from the appliance maybe very hot. Always carefully check the water
temperature. Risk of burned skin!
6. Most hot water: Turn B (gas flow) clock wise to max. and turn B counter
clockwise to min.
7. Reduce the temperature of the water: turn H counter clockwise to min. and
turn B clockwise to max.
8. When Button M is in on position “1” and there is sufficient gas and water
flow than the appliance will ignite automatically. During the ignition phase
the light C will light up. The light C will extinguish again when the flames are
in full operation.
9. To turn off the device, close the gas container and close the water tap. Switch
button M to the “0” position.
10. Turn off the appliance after every shower.
WARNING:
Frost will damage the product beyond repair and is not covered by the warranty.
In order to prevent freezing damage: drain the water from the appliance after
every shower by opening the pressure relief valve K counter clockwise.
After draining the water close valve K again.
Do not use the appliance when there is strong wind (only use at <3 beaufort wind
force)
WARNING:
Only use approved gas tubes.
Only use gas tubes between 60 and 150 cm. with a diameter between 8 and 12
mm.
Check the gas tube every 3 months for cracks or leakage. Immediately replace if
any cracks or leakages are found.
NEVER cover the appliance!
Keep inflammable, volatile and/or explosives away from the appliance.
Do not use the water from the appliance as drinking water!
4
To Next Page
Loading...
Need help?
General