30
in 1 multi country connector if required. (refer to separate delivered picture
manual related to the 3 in 1 multi country connector).
Before connecting the low-pressure regulator to the gas container, make sure that
the gas container is closed and that there are no open flames (i.e. a lit oven) in the
place where you are working. Connect the low-pressure regulator according to
the user instructions that are provided with the low-pressure regulator. Check for
gas leaks: see relative section.
• To replace the gas container, make sure that the gas container is closed
(follow the user instructions provided with the low-pressure regulator).
• Make sure that there are no open flames or other sources of heat in the area
in which you are working.
• Only change the gas cylinder in a amply ventilated area, away from any
ignition source (candle, cigarettes, other flame producing appliances, ...).
• In addition it is recommended that the gasket seals of the regulator and the
flexible rubber hose be checked to ascertain their condition. If you have any
doubt concerning the condition of the hose or the seals, replace them.
• Make sure that you do not damage the connection or any other components.
• Never turn the gas container upside down in order to make full use of the
contents. This may release liquid residues left in the container that damage
the appliance Irreparably.
• For disconnection or connection of the low-pressure regulator, always follow
the user instructions provided with the regulator.
• The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.
• Do not twist the flexible tubing or the hose.
• Connect the water hose water-in and water-out as shown in fig 7.
• Mount the shower head bracket using the 2 screws provided in the package
show in figure 8.
BATTERY:
Install the two pieces D cell batteries as shown in fig 5. NOTE the “+” and the “–“
to be in correct position!
Before use: check for any GAS LEAKS
1. Close the gas container.
2. Make sure there is sufficient ventilation.
3. Prepare a bucket of soapy water.
4. Open the gas container.
5. Brush the soapy water on all fittings and connections of the gas circuit.
6. If there is a gas leak, bubbles will rise up from the location of the leak.
7. If a leak is found, close the gas container.
8. Tighten the fitting and the metal rings of the connection.
9. Open the gas container and repeat the procedure again.
USE
- For use outdoors and in well ventilated areas.
- A well ventilated area must have a minimum of 25% of the surface area open.
4
To Next Page
Loading...
Need help?
General
