46
F HOW TO USE ADVANCED FUNCTIONS
SWING FUNCTION
Press Swing button
• The horizontal louver will swing up and down automatically when pressing Swing button. Press again
to make it stop.
• Keep pressing this button more than 2 seconds, the vertical louver swing function is activated. (Model
dependent)
LED DISPLAY:
Press LED button.
Press this button to turn on and turn off the display on the indoor unit.
Press this button more than 5 seconds(some units)
Keep pressing this button more than 5 seconds, the indoor unit will display the actual room
temperature. Press more than 5 seconds again will revert back to display the setting
temperature.
Silence function
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function(some units). Due to low frequency operation of compressor, it may result in
insufficient cooling and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean
button while operating will cancel silence function.
ECO function
Press ECO button(some units)
Press ECO button to enter the energy efficient mode.
NOTE: This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature automatically
to 24°C/75°F, fan speed of Auto to save energy (only when the set temperature is less than 24°C/75°F). If
the set temperature is above 24°C/75°F, press the ECO button, the fan speed will change to Auto, the set
temperature will remain unchanged.
G
NOTE
Pressing the this button, or modifying the mode or adjusting the set temperature to less
than 24°C/75°F will stop ECO operation. Under ECO operation, the set tmeperature should be
24°C/75°F or above, it may result in insufficient cooling. If you feel uncomfortable, just press the
ECO button again to stop it.
GB
Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 46Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 46 02-11-2021 11:3202-11-2021 11:32
To Next Page
Loading...
