Qlima WDH JA 2921 - Page 129

h
k
129
Figure 1
Paste the sealing strip in the accessories along the edge of the back for whole circle
of the machine, cut off the excessive length if needed.
Note:1.The sealing strip should be pasted along the edge of the machine, as shown in Figure1.
2. Please peel the striping layer on the sealing strip gradually while pasting.
3. Paste from the bottom of the machine first.
i
Figure 2
4. The position of the corner should be pasted as shown in Figure 2.
5. Improper pasting may cause extra noise.
j