IQ Hub v1.1
18/ 23
5 Safety Instruction
This section provides warnings that precede potentially dangerous procedures throughout this manual.
Instructions contained in the warnings must be followed during all phases of operation, service, and repair
of this equipment. You should also employ all other safety precautions necessary for the operation of the
equipment in your operating environment. If you are not sure about the precautions applicable to your
operating environment, please contact your company’s safety administrator. For basic information you
may also refer to the safety precautions per IEC704-1 listed below although Qolsys, Inc. disclaims all
responsibility for the accuracy of any statements contained therein and its applicability for your specific
environment. Failure to comply with these precautions or with specific warnings elsewhere in this manual
could result in personal injury or damage to the equipment.
Qolsys, Inc. intends to provide all necessary information to install and handle the IQ Hub in this manual.
Because of the complexity of this product and its various uses, we do not guarantee that the given
information is complete. If you need additional information, contact your Qolsys, Inc. representative.
The product has been designed to meet the standard industrial safety requirements. It must not be used
except in its specific area as specified in product specification.
Only personnel trained by Qolsys, Inc. or persons qualified in electronics or electrical engineering is
authorized to install service or maintain the product. The information given in this manual is meant to
complete the knowledge of a specialist and must not be used as replacement for qualified personnel.
Operating personnel must not remove equipment covers. Only factory authorized service personnel or
other qualified service personnel may remove equipment covers for internal subassembly or component
replacement or any internal adjustment.
Do not install substitute parts or perform any unauthorized modification of the equipment or the warranty
may be voided. Contact your local Qolsys, Inc. representative for service and repair to make sure that all
safety features are maintained.
Safety Precautions per IEC704-1
1. Read these safety instructions carefully.
2. Keep this User Manual for later reference.
3. Disconnect this equipment from any AC outlet before cleaning. Use a damp cloth. Do not use liquid
or spray detergents for cleaning.
4. For plug-in equipment, the power outlet socket must be located near the equipment and must be easily
accessible.
To Next Page
Loading...
General