IQ Hub v1.1
6/ 23
1.8 Safety Instructions for Power Cables and Accessories
Proper power source only
Start only with power source that satisfies voltage label and the voltage necessary according to
this manual. Please contact technical support personnel of Qolsys, Inc. for any uncertainty about
the requirements of necessary power source.
Power adapter Spec.
Model: SW-120100
INPUT:100-240V~50/60Hz 0.68A Max
OUTPUT: DC12.0V,1000mA
MADE IN CHINA BY SURE-POWER
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
MAKE SURE THE MECHINE IS POWER-OFF BEFORE TAKE OUT BATTERIES
Place cables properly:
Do not place cables at any place with extrusion danger.
Cleaning Instructions
Please power off before cleaning the device.
Do not use spray detergent.
Clean with a damp cloth.
Do not try cleaning exposed electronic components unless with a dust collector.
Support for special fault: Power off and contact technical support personnel of Vantron in case of
the following faults:
The device is damaged.
The temperature is excessively high.
To Next Page
Loading...
General