Screw in the other four black screws in the
corners of the right-hand side panel.
Apply the supplied four self-adhesive feet to
suitable positions on the base of the enclosure if
desired (optional).
Install the supplied knobs by tightening their
grub screws. Leave a small gap between each
knob and the front panel, to allow the knob to
turn easily. The grub screw of the volume
control knob should be at the position of the flat
on the shaft. The grub screw position on the
rotary encoder is not important.
Plug in the power…
SUCCESS!
(hopefully)
Disassembly of the QMX should follow similar steps, in reverse.
QMX assembly Rev 1.00e 58
To Next Page
Loading...
Need help?
General
