EasyManua.ls Logo

QSC BASIS 914lz - Page 25

QSC BASIS 914lz
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
Preliminary Specification
Omni Inputs 2 discrete inputs for TTL logic, voltage control or passive resistive
Connector Type 2-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration Single-ended, ground referenced
Pinout 1:+(Signal) 2:-(CHASSIS GND)
Normal Operating Range Reads signals between 0-5V nominally
Potentiometer Operation Use 10K for full range
Voltage Tolerance +/- 48V
Current Output 0.5mA with 10K pot (for passive resistive controls)
RS-232 Port Female DB9 Connector
QSControl.net Neutrik Ethercon RJ45 Ruggedized Data Connector
CobraNet Neutrik Ethercon RJ45 Ruggedized Data Connector
Indicators
QSControl.net Status Yellow Link, Tx, Rx, front panel / Green Link, Tx, Rx, rear panel
CobraNet Status Yellow Link, TX, RX, front and rear panel
Power Blue, front panel
Diagnostic Red, front panel
DataPort Status (Port) Tri-state (red, green, yellow), front panel
LCD Data Display 2 line x 16 character, backlit, front panel
Dimensions 18.89” (479.8mm) W x 1.73” (43.9mm) H x 15.00” (381.1mm) D
Weight 10.70 lb. (4.85 kg)
Specifications are subject to change without notice.

Other manuals for QSC BASIS 914lz

Related product manuals