EasyManua.ls Logo

QSC BASIS 922az - Preliminary Specifications - Interfaces and Indicators; Monitor, Relay, Logic, and Omni I;O Specs; Communication Ports and Indicators

QSC BASIS 922az
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
25
Preliminary Specification
Control Room Foldback Monitoring
Connector Type 5-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Pinout 1:+(input) 2:-(input) 3:CHASSIS GND 4:-(output) 5:+(output)
Tap points 8 internal input, 8 internal output, 8 amplifier (pre-, post-, amplifier) software
selectable
Monitor Input
Monitor Signal (unit off) Unity gain connection, relay bypass
Maximum level +21 dBu
Impedance (nominal) 10K ohms
CMRR, 20Hz-20KHz >54 dB
Monitor Output
Monitor Sum of Monitor Input and signal from internal monitor tap point(s)
Freq. Resp. 20Hz-20KHz +/- 0.5dB
Distortion (20Hz-20KHz) <0.05% @ +4dBu
Noise Floor >90dB
Output Impedance (nom) 100 Ohms
Output Load (min) 600 Ohms
Monitor Level
Control Range (nom) 0dB to -95.5dB in 0.5dB steps
Relay Outputs 2 discrete floating relay switch outputs
Connector Type 3-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration Electromechanical Relay
Pinout 1:NC 2:NO 3: COM
Switching Capacity (nom) 1A 30VDC
Logic Outputs 4 discrete outputs
Connector Type 2-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration Single-ended, TTL compatible
Pinout 1:+(Signal) 2:-(CHASSIS GND)
Omni Inputs 6 discrete inputs for TTL logic, voltage control or passive resistive
Connector Type 2-pin "Phoenix Style" (a.k.a. "Euro Style") detachable terminal blocks
Configuration Single-ended, ground referenced
Pinout 1:+(Signal) 2:-(CHASSIS GND)
Normal Operating Range Reads signals between 0-5V nominally
Potentiometer Operation Use 10K for full range
Voltage Tolerance +/- 48V
Current Output 0.5mA with 10K pot (for passive resistive controls)
RS-232 Port Female DB9 Connector
QSControl Neutrik Ethercon RJ45 Ruggedized Data Connector
CobraNet Neutrik Ethercon RJ45 Ruggedized Data Connector
Indicators
QSControl Status Yellow Link, Tx, Rx, front panel / Green Link, Tx, Rx, rear panel
CobraNet Status Yellow Link, TX, RX, front and rear panel
Power Blue, front panel
Diagnostic Red, front panel
DataPort Status (Port) Tri-state (red, green, yellow), front panel
LCD Data Display 2 line x 16 character, backlit, front panel
Specifications are subject to change without notice.

Related product manuals