QSC KS212C - Menu Functions Explained; Crossover and Delay Settings; Scene Management; Utility Functions

13
TD-001536-01-A
Menu Listing
CROSSOVER Select the CROSSOVER setting
CROSSOVERS
80 Hz
100 Hz
CROSSOVERS
80 Hz – applies a 80 Hz low-pass filter. 80 Hz is optimized for the K.2 Series
and future loudspeakers
100 Hz – applies a 100 Hz low-pass filter. 100 Hz is optimized for the legacy K,
KLA, and KW loudspeakers
Both of the crossover frequencies are time-aligned with the K.2 Series when
the K.2 loudspeaker is pole-mounted over the KS212C and the front edges of
the KS212C and K.2 Series loudspeakers are parallel.
DELAY Select the DELAY setting
DELAY
1.69 FEET
DELAY
1.50 ms
0.51 METERS
0 –100 milliseconds, 0 – 113 feet, 0 – 34 meters
All units of measure change together when the selection knob is turned.
SCENE Save or recall a user-defined SCENE
SCENE MENU
RECALL SCENES
SCENE MENU
SAVE SCENES
Use the selector knob to scroll (up or down) to the function you want
SAVE SCENE
TO
USER 1 – 5
USER 4
SAVE SCENE TO
USER 3
USER 2
Use the selector knob to scroll (up or down) to select the scene name for the
current settings. When you save a scene all the current settings in the amplifier
are saved to that scene. Choose from User 1 through User 5, then press the
enter button.
When saved, a triangle displays next to the saved scene, and the scene is the
active scene.
RECALL
SCENE
USER 1 – 5
LOAD
BACK
USER 1
USER 2
RECALL SCENE
USER 3
The active scene is indicated by the triangle to the right of the scene name. Use
the selector knob to scroll (up or down) to select the scene you want to recall.
Press the LOAD (enter) button to recall the selected scene.
SETTINGS Utility functions
SETTINGS
menu
LED
KS 212C 1.0.6.2844
CONTRAST
FACTORY RESET
Displays the loudspeaker model, firmware version (cannot edit this field) and the
available utility selections. Use the selector knob to select the utility you want,
then press the enter button.
LED
FRONT AND REAR
REAR ONLY
LED
FRONT ONLY
Selects which combination of front and rear LEDs illuminate,
CONTRAST
LEVEL 8
CONTRAST
TEST TEXT
Adjusts the contrast of the LCD. Selections are 0 – 15, default is 8. The screen
changes as you adjust.
FACTORY
RESET
YES
NO
USER PRESETS AND
SETTINGS WILL BE
SET TO DEFAULT
FACTORY RESET
CONTINUE?
Resets all parameters to the factory defaults, clears user presets – no undo.