Need help?Do you have a question about the QUAD 303 and is the answer not in the manual?
General| Power Output | 45 watts per channel into 8 ohms |
|---|---|
| Total Harmonic Distortion | <0.1% at full power |
| Speaker Load Impedance | 4 to 16 ohms |
| Type | Solid State |
| Input Impedance | 100kΩ |
| Damping Factor | Greater than 50 |
| Signal to Noise Ratio | >90dB |
Describes the signal path and components of the Quad 33 unit.
Explains how to access components within the Quad 33 unit.
Explains the triple configuration of the output stage transistors.
Describes the circuitry for limiting the current of Tr102.
Presents a simplified circuit diagram of the Quad 303.
Explains the function and regulation mechanism of the regulator board.
Provides step-by-step instructions for setting up the Quad 303 unit.
Describes intermittent contact issues with plug-in boards and their solution.
Details modifications for the Quad 33 based on serial numbers.
Details modifications for the Quad 303 based on serial numbers.
Lists components for the Quad 303 Regulator Board M12035, referencing Fig. 12.
Lists components for the Quad 33 Disc Board M.12021, referencing Fig. 4.
Lists general components for the Quad 303, referencing Fig. 10.
Lists components for the Quad 33 Pre-amplifier Board M.12019, referencing Fig. 5.
Lists components for the Quad 33 Tape Board M.12027, referencing Fig. 6.
Lists components for the Quad 33 Amplifier Board M.12017, referencing Fig. 7.
Lists components for the Quad 33 Power Supply Board M.12032, referencing Fig. 9.
Lists components for the Quad 33 Filter Board M.12029, referencing Fig. 8.
Lists general components for the Quad 33, referencing Fig. 3.
To Next Page
