Need help?Do you have a question about the QUAD 306 and is the answer not in the manual?
General| Input Impedance | 20k ohms |
|---|---|
| Power Output | 50 watts per channel into 8 ohms |
| Input Sensitivity | 775mV for 50W into 8Ω |
| Signal to Noise Ratio | >100dB |
| Dimensions | 321 x 64 x 207 mm (Width x Height x Depth) |
Illustrates the principle of the current dumping amplifier circuit used in the Quad 306.
Ensures the amplifier is connected to the correct voltage supply.
Instructions for connecting the amplifier to the mains power.
Details the unswitched AC power output socket for powering other units.
Recommendations for placing the amplifier for optimal performance and safety.
Guidance on connecting the amplifier to a Quad control unit for audio input.
How to connect loudspeakers to the amplifier, including phasing.
Details the resettable current trip that protects the amplifier from overload.
Discusses amplifier power limits for loudspeakers and manufacturer advice.
Compatibility and specific considerations for Quad ESL loudspeakers.
Explains how to check and ensure correct loudspeaker phasing.
Information on using headphones with the amplifier and switch units.
Instructions for cleaning and maintaining the amplifier's exterior.
Identifies and describes connectors and controls on the rear panel.
To Next Page
