QUAD 99 Series - FM Tuner & Pre-Amplifier Specifications

11
3 Aux & tape inputs
Sensitivity
Signal-to-Noise-Ratio
Distortion
Phono inputs - MM (MC)
Sensitivity
Signal-to-Noise-Ratio
Distortion
Pre-Amp Output
Level
Source Impedance
AMPBUS Output
Level
Source Impedance
Tape Output
Level
Source impedance
Frequency response
All inputs except
MM & MC
MM & MC inputs
Dimensions ( H x W x D )
100, 300 or 775 mV
›97 dB (A) ref.775 mV
‹0.002%
1,3 or 7.75 mV (100, 300 or 775 uV)
78 dB (A) ref.775 mV (775 uV)
‹0.005% (‹0.01%)
775 mV (3.3 volts maximum)
100 ohms
2 volts (8 volts maximum)
20 ohms
100, 300 or 775mV (10V maximum)
330 ohms
10 Hz to 20 kHz +0dB /- 0.3 dB
3 Hz to 56 kHz +0dB/- 3 dB
20 Hz to 20 kHz +/- 0.5 dB
7 Hz to 53 kHz +0.5dB/- 3 dB
70mm x 321mm x 310mm
The 99 Pre-amplifier has an
intelligent control system to
communicate with all
components connected via
the ‘Quad-Link’ connector.
FM Tuner Pre-Amplifier
Tuning range
Channel spacing
Sensitivity (30dB quieting)
Sensitivity (50dB quieting)
Full limiting
Signal-to-noise ratio
(1mV, 1kHz)
Distortion
(1kHz, 25kHz deviation)
Capture ratio
IF rejection
AM surpression
Image rejection
Pilot tone surpression
Cross-talk
De-emphasis
Aerial input
Dimensions ( H x W x D )
88 to 108 MHz
50 kHz
Mono 8 dBuV
Mono 18 dBuV
Stereo 18 dBuV
<1 uV (1.2 dBf)
Mono 72 dB (A)
Stereo 67 dB (A)
Mono 0.03%
Stereo 0.05%
1.5 dB
>100 dB
>60 dB
>80 dB
>60 dB
-40 dB at 1 kHz
50 uS or 75 uS
2 x 75 ohms un-balanced
(70mm x 321mm x 310mm)