Need help?Do you have a question about the QUAD EZ-4000 and is the answer not in the manual?
General| Brand | QUAD |
|---|---|
| Model | EZ-4000 |
| Category | Door Opening System |
| Language | English |
Provides essential first steps and safety warnings for installation and operation.
Outlines daily inspection procedures to ensure safe operation of the automatic door system.
Warns against improper installation/adjustment and prohibits self-repair, directing users to suppliers.
Details the manufacturer's warranty terms, coverage, and limitations for the products.
Explains how products are distributed and serviced through authorized distributors.
Provides guidance and diagrams for securely mounting the header unit to the door frame.
Details the process of installing the operator and controller unit within the header assembly.
Explains how to attach and position the door arm, rod, and swivel for operation.
Presents diagrams and tables for precise measurements related to door and header mounting.
Provides step-by-step instructions for installing the parallel arm and track system.
Details the initial wiring steps for the ES-500 control, including power and switch connections.
Guides through the initial setup process and explains how to adjust parameters using the control.
Covers procedures for adjusting latch check, closing speed, and latch speed.
Details how to adjust open check switch, limit, and obstruction sensing features.
Explains how to connect external actuating devices, locks, and safety sensors.
Lists and explains the status codes displayed by the ES-500 control during operation.
Provides a comprehensive list of adjustable parameters, their functions, and default values.
Offers specific instructions and considerations for installing two operators in a synchronized pair.
Illustrates the connection of a Larco wireless receiver to the ES-500 control board.
Presents recommended and not recommended wiring methods for electric door locks.
Explains the operation and integration of the BEA Bodyguard sensor with the ES-500 control.
Details wiring and compatibility for Optex Premier and OA Edge safety sensors.
Shows the pin connections and wiring schematic for the Optex 904C sensor with the ES-500.
Explains how to configure the ES-500 to prevent the "push and go" feature with the Super Scan.
Addresses compatibility between Quad Systems operators and Horton controls, and vice-versa.
Provides a simplified explanation for adjusting the door operator cams.
Explains how to set up motion sensors for safety and how they function when the door is open or closed.
Covers safety beam settings, UL parameter, safety mats, and other safety features.
Lists the default programming settings for the ES-500 board with the 4000 series chip.
Lists the default programming settings for the ES-500 board with the EZ-7000/28k series chip.
To Next Page
