- 5 -
CAUTION
An improperly installed and/or adjusted Automatic Door can cause injury and
equipment damage.
Door must be installed and adjusted as described in this Owner’s Manual by a certified
professional.
All required safety devices must be in place and operational.
Door must be inspected DAILY. If the door is not functioning correctly it must be taken
out of Automatic Service immediately until a Certified Technician inspects and repairs
the unit.
DO NOT ATTEMPT TO ADJUST OR REPAIR THE DOOR YOURSELF
CALL YOUR AUTOMATIC DOOR SUPPLIER FOR REPAIRS
To our Customers
The purpose of the manual is to familiarize you with your automatic door system. It is essential that you
know your system and that you recognize the importance of maintaining your door system in compliance
with the industry standards for safety.
It is your responsibility, as owner or caretaker of the equipment, to inspect the operation of your door
system on a daily basis, and after any loss of electrical power, to ensure that it is safe for use by your
invitees, customers, or employees.
Daily Safety Checks are the responsibility of the equipment owner or caretaker. The Following safety checks
are to be done daily and/or after any electrical power outages:
1. When actuated, the door should slowly open at a smooth pace (5 seconds min.) until gently stopping
at the pre-set fully open position.
2. The door should hold open for the pre-set time of not less than 5 seconds
3. The door should then slowly close at a smooth pace (5 seconds min.) and stop gently.
4. Make sure the traffic path and threshold area are clean and clear inside and outside of doorway
5. Inspect the door, safety decals, connecting arms, hardware and glass for wear or damage.
To Next Page
Loading...