8
Ensure Hitch Security Pin is in
place - through the ATV hitch pin
x
9
Ensure the Deck Restraining
Chains are secure – BOTH ENDS
x
10
Ensure that Hitch Assembly on the
Mower is secure and moves freely
x
11
Remove any Debris build up on
Engine Cooling Air Intake.
x
11
Shut Fuel OFF after usage session
is over – NOTE – fuel valve located
beneath the fuel tank.
x
12
Check Deck Drive Belt Tension –
Engine to the Mower Deck
x
13
Do general Engine Check -
including the air filter check
x
14
See the Engine Manufacturers
recommendations for servicing.
x x
15
Replace Mower Blades
x
16
Check Deck & Drive Belts for
Physical Wear
x
5.2 Blade Replacement
To avoid personal injury ALWAYS handle the
blade with care to avoid injury!
CAUTION
The blade retaining bolts have Right Hand Threads –
turn the bolts counterclockwise to loosen!
IMPORTANT
The blades should be kept sharp at all times. Sharpen the cutting edges if they appear like blade
labeled – 2. Any blade that resembles – 3 – should be replaced immediately.
Check the blades on the HyperCut Mower by lifting the deck, blocking it on one side and
then examining the blades; if they need to be sharpened or changed remove the HyperCut
Mower from the ATV.
Replace mower blades that have been
damaged or deeply nicked.
IMPORTANT
To Next Page
Loading...