EasyManua.ls Logo

Quadro RF-2451MA+ - Installing and Operating Your Freezer

Quadro RF-2451MA+
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN -5-
Do not place glass bottles or beverage cans in the ice-making
compartment as they can burst as the contents freeze.
          
drinks with high alcohol content vertically in the freezer and make sure
that their tops are tightly closed.
When removing ice from the ice-making compartment, do not touch it. Ice may
cause frost burns and/or cuts.
Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes immediately
after you have taken them out of the ice-making compartment.
Do not re-freeze frozen goods after they have melted. This may cause health issues such
as food poisoning.
Do not cover the body or top of freezer with lace. This affects the performance of your
freezer.
Secure any accessories in the freezer during transportation to prevent damage to the
accessories.
Installing and operating your freezer
Before starting to use your freezer, you should pay attention to the following points:
• The operating voltage for your freezer is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded usage.

Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and at least 5 cm away from electrical ovens.


them to prevent humidity forming on the outer surface.
• Do not place heavy items on the appliance.
Do not place anything on your freezer, and install your freezer in a suitable
place so that at least 15 cm of free space is available above it.
Use the adjustable front legs to make sure your appliance is level and
stable. You can adjust the legs by turning them in either direction. This
should be done before placing food in the freezer.
Before using your freezer, wipe all parts with a solution of warm water and a teaspoon of
sodium bicarbonate, then rinse with clean water and dry. Place all parts in the freezer
after cleaning.
Install the plastic distance guide (the part with black vanes at the rear)

touching the wall.
The freezer should be placed against a wall with a free space not


Table of Contents