1312
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
Customer Helpline 0845 034 2279
www.gardenservicecentre.co.uk
How to Use the Safety Strap
Step 1 - Pulling the red safety strap releases the product quickly
How to Replace the Spool/Spool Line
Step 1 - Removing the spool
– Twist off (clockwise to loosen) and remove the cover of the spool.
– Remove the spool.
Do not lose the spring!
SPRING
SLOTS
STRING HEAD
EYELETS
SHAFT
SPOOL COVER
Operating the Brush Cutter
Operating the Brush Cutter
Hold the brush cutter with both hands on the U type handle, while the right handle controls the
throttle.
WARNING! Keep a rm grip with both hands while in operation.
NOTE! Brush cutter should be held at a comfortable position with the trigger handle about hip
height. Maintain your grip and balance on both feet.
WARNING! Position yourself so that you will not be thrown off balance by the kickback reaction
of the cutting blade.
NOTE! Adjust the shoulder harness to position the brush cutter at comfortable operating position
and to assure that the shoulder harness will reduce the risk of operator contact with the blade.
WARNING! Exercise extreme caution when using the blade with this unit. Blade thrust is the
reaction that may occur when the spinning blade contacts anything it cannot cut. This contact
may cause the blade to stop for an instant, and suddenly” thrust” the unit away from the object
that was hit. This reaction can be violent enough to cause the operator to lose control of the unit.
Blade thrust can occur without warning if the blade snags, stalls, or binds. This is more likely
to occur in areas where it is difcult to see the material being cut. For cutting ease and safety,
approach the weeds being cut with the brush cutter, from the right to the left. In the event an
unexpected object or woody stock is encountered, this practice could minimize the blade thrust
To Next Page
Loading...
Need help?
General
