ASSEMBLY
IMPORTANT! Before you assemble the
lawn mower, check all accessories
listed have been supplied. If parts or
accessories are missing contact the Helpline
for advice.
1. FITTING THE HANDLE (See Fig A1, A2, A3)
1) Remove the screws (X 2) on the both side
of poles. (Fig A1)
A1
2) Insert the lower handle (8) into the holes
provided.
3) Secure with the screws provided.(Fig A2)
A2
4) Attach the upper handle (6) with the bolts
and handle knobs (4) to the lower handle
(8).(Fig A3)
A3
NOTE: Ensure the bolts are fully inserted
through the lower and upper handles before
xing the handle knobs. Use the cable clips
(3) provided to x the cable to the lower
handle, ensuring there is enough slack to
allow for movement.
2. GRASS COLLECTION BAG ASSEMBLY
Connect the grass box handle to the box top
as shown in Fig B1-B4.
Step1: Press the handle gently in direction of
arrow 1 to locate it in position. (Fig B2)
Step2: Then push it forward in direction of
arrow 2. (Fig B2)
Step3: Push down the back of the handle in
direction of arrow 3. (Fig B2)
Step4: Finally, clip the plastic clips on the
collection bag over the metal frame. (Fig B3)
WARNING: Don’t t the handle in
reversed direction. Fit the handle as
shown in Fig B1.
B1
Front part
Back part
To Next Page
Loading...
Need help?
General
