1514
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Troubleshooting
General Troubleshooting
CAUTION!
- Always switch off the engine and pull the ignition cable before starting any inspection or
adjustment work.
- Remember that the exhaust and other parts will get hot after running the engine, even if only for
a few minutes.
Storing the Hedge Trimmer
Maintenance
Maintenance Schedule
Step 1 - Storing the Hedge Trimmer for Short Periods
• Drain all fuel from tank into a container approved for petrol. Run engine until it stops. Clean
all foreign material from the trimmer. Store it in a well-ventilated place that is out of reach from
to children.
• Keep away from corrosive agents such as garden chemicals and de-icing salts.
• Abide by all ISO and local regulations for the safe storage and handling of petrol. Excess fuel
should be used up in other 2-Stroke engine powered equipment or disposed of at your local
recycle centre.
• Remove any coarse dirt.
• Wipe the machine with a soft damp cloth.
Performing routine maintenance correctly on your hedge trimmer will ensure you get years of
trouble free use.
Please keep this manual safe for future reference.
It is recommended that the following maintenance schedule is adhered to. This will ensure the
hedge trimmer operated correctly and is safe to use.
12 hours of use 24 hours of use 36 hours of use
Air lter clean clean replace
Spark plug check clean replace
Step 2 - Storing the Hedge Trimmer for Extended Periods
• All the above plus: Clean air lter and replace the spark plug with an exact replacement.
WARNING! Always switch off the hedge trimmer and remove the spark plug boot before carrying
out any maintenance work.
List of consumable Qualcast parts
984125 air lter
984002 spark plug
984124 Fuel lter
Blade lubrication
Only clean the machine after it has been switched off. Use only mild soap and a damp cloth to
clean it. Never allow uid to get into the machine. Do not use caustic cleaning products.
Ensure that the blade’s cutting edge is always well oiled.
Fault Possible Cause Solution
Engine not starting 1. Empty tank
2. Flooded engine
3. Fouled spark plug (remains of
carbon on the electrodes)
4. Electrode gap too large
5. Fouled carburetor or its jets
6. Damaged spark plug connection
or damaged spark plug
1. Fill up
2. Close the throttle, pull cord several
times, if required take out the spark plug
and dry it
3. Clean the spark plug, check its
temperature, replace if needed.
4. Adjust at 0.6-0.7 mm
5. Clean the carburetor with air
6. Replace the spark plug.
Engine runs too fast
when idle
1. Cold engine 1. Warm up slowly; alternatively close
the choke a bit.
Engine does not
reach its maximum
speed
1. Fouled spark plug (remains of
carbon on the electrodes) spark
gap to large
2. Fouled carburettor or its jets
3. Fouled air lter
4.Exhaust, exhaust channel
5. Sealing ring in crankcase not
sealing properly
6. Worn cylinders, pistons and
piston rings
7. Wrong fuel mix (too much oil)
8. Bad ignition
1. Clean the spark plug, check its
temperature, replace if needed. Adjust
at 0.6-.07 mm.
2. Clean the carburettor with air
3. Clean
4. Take out the exhaust and clean it,
remove remains of carbon
5. Replace
6. Replace the cylinder, piston or piston
rings, reface the cylinder and piston,
assembly
7. Fill up according to the instructions
8. Adjust the ignition coil gap (0.3-0.4
mm)
Engine would not
stop
1. The switch was failed.
2. The wiring terminal was
disconnected.
1. Change the switch.
2. Connect up the wiring terminal.
These parts are available via
www.gardenservicecentre.co.uk
The following table provides solutions to common problems encountered with the hedge trimmer.
To Next Page
Loading...
