1312
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Cleaning the Air Filter
Replacing the Spark Plug
Cleaning the air lter
1) Loosen the screw from the air lter housing and remove the cap.
2) Remove the air lter.
3) Wash the air lter in warm water (with a small amount of detergent).
4) Rinse the air lter through with clean water.
5) Leave the air lter to dry out completely.
6) Replace the air lter.
7) Replace the cover with the lugs positioned in the notches in the air lter casing.
8) Close the lid, and tighten the bolt again by screw driver.
Replacing the spark plug
1) Pull off the ignition cable plug.
2) Use the plug wrench to unscrew and remove the spark plug.
3) Insert a new spark plug and tighten it carefully with the plug wrench.
4) Snap the ignition cable plug back on.
H=0.6-0.7 mm
WARNING! Always turn off engine before performing maintenance tasks.
Operating the Hedge Trimmer
Step 4 - Trimming (continued)
Always start with the sides. Guide the hedge trimmer along an arch route up and down and keep
cutting. You should be using both blade sides.
When cutting hold the hedge trimmer at the angle of about 15° and guide it horizontally across
the hedge. When cutting the top part guide the trimmer in a sickle like movement toward the
hedge edges. Cut branches will then fall on the ground.
- Do not cut hedges out of the main trimming and pruning season.
- If the branches are bigger than 22mm, they must be removed by pruning shears.
- If heavy pruning is required, you should work in stages.
The hedge trimmer is equipped with an automatic brake system for quick stop which stops the
blade immediately once the throttle is released to prevent a possible accident.
If you want to switch off the machine completely, you must move the switch into the “OFF“
position.
Stopping
Stopping
To Next Page
Loading...
