GB • Printed in England • BA F 016 L69 881 • Powertrak 340 • OSW 02.10
Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance
away) and EN 25 349.
34 Models: Typically the A-weighted noise
level of the product is: sound pressure level
84 dB (A); sound power level 95 dB (A).
400 Model: Typically the A-weighted noise
level of the product is: sound pressure level
85 dB (A); sound power level 96 dB (A).
The typical hand/arm vibration is below
2.5 m/s
2
.
We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization documents:
EN 60 335, EN 836 according to the provisions
of the directives 89/336/EEC, 98/37/EC,
2000/14/EC.
2000/14/EC: The guaranteed sound power
level L
WA
is lower than 96 dB (A). Conformity
assessment procedure according to An-
nex VI.
Notified body: SRL, Sudbury England
PLACE: Stowmarket, 01.02.2002
Signature: Director
Atco-Qualcast guarantees this product
against manufacturing defects. We will repair
(or replace at our option) if a manufacturing
defect occurs within the guarantee period as
long as it has only been subjected to domes-
tic use.
For the purpose of this guarantee, domestic
use means any use of the product on the
property belonging to the purchaser and
forming part of the garden area of his/her
dwelling.
The guarantee period is 5 years parts and
2 years labour costs from date of purchase.
To obtain a repair under this guarantee:
• Take the product to an approved service
agent.
• Show your dated proof of purchase.
• Show this guarantee.
The guarantee does not apply if:
i. You cannot provide dated proof of pur-
chase.
ii. The product has been resold by the original
purchaser (this does not apply in the Repub-
lic of Ireland), or has been used under hire.
iii. The product has been modified to change
the manufacturers specifications, or if non
genuine replacement parts have been fit-
ted.
iv. Any previous repair was undertaken by any-
one other than an approved service agent.
v. The fault is due to maladjustment, abuse, ne-
glect or accidental damage.
vi. The fault is due to lack of lubrication or main-
tenance.
vii. Damage to any part, particularly the drive
or cutting mechanism has been caused by
allowing the product to strike solid objects.
viii. The product develops a fault due to abnor-
mal use.
ix. Failure is due to normal wear. The following
parts are considered as wearing parts. Their
life is dependant on regular servicing and
they are not therefore, normally covered by
the guarantee:
Blades
Bearings
Cables
The cost of routine maintenance of the prod-
uct is not covered by the guarantee.
It is in your best interest to follow the Operat-
ing Instructions for your machine, as a prop-
erly cared for product should give many
years of excellent service.
Should you require replacement parts, al-
ways insist on genuine Atco-Qualcast re-
placement parts. Any damage caused to
the product through the fitting of parts not
made by Atco-Qualcast is not covered by
the guarantee.
Your statutory rights are not affected by this
guarantee.
Environmental Information
Your product has been manufactured under
an environmental management system us-
ing, when possible, the most environmentally
responsible materials and processes, and
with the potential for recycling at the end of
its life. The packaging is also recyclable.
The plastic components are labelled for cat-
egorized recycling.
When the time comes to dispose of this prod-
uct please consider the environment and
take it to a recognised recycling facility.
(Please contact your local authority for loca-
tion information).
Declaration of Conformity
Guarantee
F016 L69 881 - GB Seite 8 Freitag, 8. November 2002 9:25 09
To Next Page
Loading...
