Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
CLI Error Codes 103
E0106 Command: data validation is not implemented yet
E0107 Command: do-function is not implemented yet
E0108 Command is not specified.
E0109 One or more required options are missing.
E0110 Option is incompatible with another option specified earlier.
E0111 Option is not supported on this system!
E0120 Option required a value but the value was not specified.
E0121 Option does not have a value
E0122 Option has invalid value
E0123 Command cannot be in file
E0124 Command must have at least one option specified!
E0129 Option has values that are mutually exclusive.
E0130 Two or more mutually exclusive options are specified!
E0131 Must specify one of the mutually exclusive options!
E0132 Command was cancelled successfully as requested!
E0133 Command was not sent to noded!
E0134 Request was submitted. The result may take a few minutes.
E0140 The function is not implemented yet.
E0200 Command is not supported in Web Services
E0300 Exception caught in SYS Init method
E0301 Exception caught in SYS Run method
E0302 Exception caught in WSS Convert method
E0303 Exception caught in WSS Run method
E0304 Exception caught in WSC Init method
E0305 Exception caught in WSC Run method
E0306 Exception caught in syscli main.
E0307 Exception caught in QSys function.
E0310 Exception caught in ShareCache class.
E0311 Exception caught in ShareConfig class.
E0312 Exception caught in retrieving share replication information.
E0313 Exception caught in reading share info.
Error Code Error Message
To Next Page
Loading...
Need help?
General