EasyManua.ls Logo

Quantum LTO-8 HH SAS

Quantum LTO-8 HH SAS
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Technical Reference Manual
Quantum LTO-8 HH SAS
User’s Guide
6-68132-03 Rev A

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Quantum LTO-8 HH SAS and is the answer not in the manual?

Quantum LTO-8 HH SAS Specifications

General IconGeneral
Native Capacity12TB
Compressed Capacity30TB
Native Data Transfer Rate300 MB/s
Buffer Size1GB
MTBF250, 000 hours
Media TypeLTO Ultrium 8
InterfaceSAS
Compressed Data Transfer Rate750 MB/s
EncryptionAES 256-bit
Backward CompatibilityLTO-7, LTO-6
CompatibilityLTO-8

Summary

Chapter 1 Preface

Safety notices

Explains danger and caution notices, their symbols and meanings.

Performing the Safety Inspection Procedure

Steps to perform before servicing the unit, including power and cable checks.

Tape drive AC grounding inspection

Details the procedure for inspecting the tape drive's AC grounding.

Rack Safety

General safety guidelines for rack-mounted devices, including loading and power.

Chapter 2 Introduction

Chapter 3 Installation

Avoiding Drive Damage

Precautions to prevent static electricity damage when handling the drive.

Inspect the Power Cord and Outlet

Instructions for inspecting the power cord and ensuring the outlet is properly grounded.

Connect the SAS Interface Cable

Details on connecting the SAS interface cable between the drive and the host adapter.

Connect Power

Steps for connecting the power cord and powering on the tape drive.

Run Drive Diagnostics

Instructions on how to run standalone drive diagnostics.

Install Device Drivers

Information on installing necessary device drivers for the tape drive.

Configure the Tape Drive to a ServerHost

Guidance on configuring the tape drive for server or host integration.

Updating firmware

Procedures for updating the drive's firmware using various methods.

Chapter 4 Operations

Cleaning the Drive Head

Guidance on when and how to clean the drive head using a cleaning cartridge.

Diagnostic and Maintenance Functions

Overview of diagnostic and maintenance functions and access methods.

Chapter 5 Media

Cleaning Cartridge

Describes the Quantum LTO Ultrium Cleaning Cartridge and its use for cleaning drive heads.

Chapter 6 Troubleshooting

Procedure 1: Determining Firmware Level and Capturing Drive Dump

Steps to check the current firmware level and capture drive dumps.

Procedure 2: Inspecting a Cartridge for Damage

Steps to identify and address cartridge loading or unloading issues.

Procedure 3: Checking SAS Host Connections

Guide to verifying SAS cable, adapter, and server connections for communication problems.

Resolving Problems Reported by the Server

Describes procedures for fixing interface bus errors, including SAS bus issues.

Resolving Media-Related Problems

Explains how the drive's firmware assists in diagnosing media-related issues.

Pre-Call Checklist

A checklist to perform before contacting Quantum Technical Support for assistance.

Related product manuals