Chapter 4: Operations
Inserting a Tape Cartridge
QuantumLTO-8 HH SAS User’s Guide 41
Inserting a Tape Cartridge
To insert a tape cartridge:
1 Ensure that the drive is powered-on.
2 Ensure that the write-protect switch on the tape cartridge is
properly se
t (see
Write-Protect Switch on page 76).
Force a drive dump (part of the
maintenance mo
de)
Caution: If the drive detects a permanent error and displays an
error code, it automatically forces a drive dump (also
known as a save of the firmware trace). If you force a
drive dump, the existing dump will be overwritten
and data will be lost. After you force a drive dump,
do not turn off the power to the drive or you may
lose the dump data.
Choose one of the following procedures:
• If the drive is in maintenance mode (Read
y l
ight is flashing
and Fault light is On for Maintenance mode), refer to
Function Code 4: Force a Drive Dump on page 52.
• If the drive is in operating mode (Ready li
ght is On or
flashing), press and hold the Unload button for ten seconds.
If captured dump data exists, the drive places it into a dump
area (for i
nformation about retrieving the data, see
Procedure
1: Determining Firmware Level and Capturing Drive Dump on
page 83).
Reset the drive Press and hold the Unload button
until the drive begins the
reset procedure (Fault light will turn On when reset starts).
Note: If a tape cartridge is loaded in the drive the drive will
unload the tape. Repeat the
Reset the drive
procedure
after the tape is unloaded. The drive saves a dump of the
current drive state, then reboots to allow
communication. Do not cycle power as this will erase the
contents of the dump.
Unload button Function How to Initiate the F
unction
To Next Page
Loading...
Need help?
General
