QuantumLTO-8 HH SAS User’s Guide 1
Chapter 1
Preface
This guide describes how to install and use the Quantum LTO-8 Tape
Drive in the following chapters:
Chapter
2, Introduction describes the product, discusses supported
servers, operating systems, an
d device drivers, and lists hardware
specifications.
Chapter
3, Installation gives unpacking, set up, and configuration
information.
Chapter
4, Operations describes the Power Button, Unload Button, and
Status lights and explains the function of the Single-character Display.
It gives instruction on inserting and remo
ving a tape cartridge, describes
methods of updating drive firmware, and explains how to clean the
tape drive. It also lists diagnostic and maintenance functions.
Chapter
5, Media describes the types of tape cartridges to use and
defines the conditions for storing and shipping them. It also describes
how
to handle the cartridges, how to set a cartridge's write-protect
switch, and how to order additional cartridges.
Chapter
6, Troubleshooting gives tips for solving problems with the
drive.
Appendix
A, Error Codes and Messages describes the error and
informational codes that appear on the single-character display.
To Next Page
Loading...
Need help?
General
