Quantum DXi V1000 - Page 253

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
CLI Error Codes 245
E6009202 SetParam: Option "set" requires a value
E6009203 SetParam: Option "set" has invalid value
E6009204 SetParam: Failed to read/get option "set".
E6009205 SetParam: Failed to write/set option "set".
E6009211 SetParam: Option "filename" is missing.
E6009212 SetParam: Option "filename" requires a value
E6009213 SetParam: Option "filename" has invalid value
E6009214 SetParam: Failed to read/get option "filename".
E6009215 SetParam: Failed to write/set option "filename".
E6009221 SetParam: Option "section" requires a value
E6009222 SetParam: Option "section" has invalid value
E6009223 SetParam: Failed to read/get option "section".
E6009224 SetParam: Failed to write/set option "section".
E6009231 SetParam: Option "name" is missing.
E6009232 SetParam: Option "name" requires a value
E6009233 SetParam: Option "name" has invalid value
E6009234 SetParam: Failed to read/get option "name".
E6009235 SetParam: Failed to write/set option "name".
E6009241 SetParam: Option "value" is missing.
E6009242 SetParam: Option "value" requires a value
E6009243 SetParam: Option "value" has invalid value
E6009244 SetParam: Failed to read/get option "value".
E6009245 SetParam: Failed to write/set option "value".
E6009251 SetParam: Failed to read/get option "nocheck".
E6009252 SetParam: Failed to write/set option "nocheck".
E6009291 SetParam failed!
E6009292 SetParam: Failed to change the specified parameter!
E6009293 SetParam: Failed to add the new parameter!
E6009294 SetParam: Failed to set parameter!
E6009295 SetParam: Parameter not found!
E6009296 SetParam: Failed to reload 'noded' daemon!
Error Code Error Message