7
Parts Preparation Parts Preparation Parts Preparation
Parts Preparation Parts Preparation
Parts Preparation
Parts Preparation Parts Preparation
Parts Preparation
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Unthread then depress
the Presta valve to release
the air pressure. Hold
the valve stem and use
the Presta valve tool to
remove the valve core.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at least 6
mm of valve stem extending
above the rim, not including
the valve core, for adequate
clearance.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at least 6
mm of valve stem extending
above the rim, not including
the valve core, for adequate
clearance.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at
least 6 mm of valve stem
extending above the
rim, not including the
valve core, for adequate
clearance.
Make sure there is at least 6
mm of valve stem extending
above the rim, not including
the valve core, for adequate
clearance.
1
2
Remove/Loosen Retirer/Desserrer Retirar/Desapertar
Entfernen/Lösen Rimuovere/Allentare
取り外し/ 緩める
Quitar/Afl ojar Verwijderen/Losmaken
拆卸/旋松
Adjust Régler Ajustar
Einstellen Regolare
調節
Ajustar Afstellen
调节
≥ 6 mm
Measure Mesurer Medir
Messen Misurare
計測
Medir Meten
测量
To Next Page
Loading...
