Switching on the device – briefly pressing the button on / off
the device. Turn off the device - press the on / off button of
the device.
The “*” symbol is displayed when the backlight is on, it is not
recommended to search with the backlight on during daylight
hours, this significantly increases power consumption.
8.0 V in this case, this is a supply voltage of –8.4 V equal
to the full charge of the batteries; at a voltage of 6.0 V, the
device will begin to signal a discharge. The value of the
supply voltage is alternately replaced by the value of the
soil balance in the format "0.0", and the value of the
current value in the TX in the format "00 mA", the value of
the supply voltage is displayed in the format "0.0V"
In the operating mode, the Up / Down buttons can be used to
quickly change the Barrier value — the higher the value, the
less false alarms, with the help of a barrier it is possible to
reduce the parasitic effect of noise on the operation of the
device, to achieve comfortable operation. The value can be in
the range from 1 to 32. Barrier - smooth adjustment, it is not
necessary to ascribe the emurol of the depth regulator, but
there is no abuse of the increase in the barrier, the device may
lose a few centimeters in depth.
To Next Page
Loading...
Need help?
General