Coming from the main-page you have to press the “EDIT/OK” key to enter the edit menu. By Using the
listen to the changes immediately you first have to select the part corresponding to the send-channel of
your connected keyboard.
<1>
Part\13\SndGroup
|1>\SynthLead
To accelerate the search for a specific sound, all sounds are divided into groups.
With the “VALUE”-dial the groups can be selected.
<2>
Part\13\Sound
<2>\_303Lead
On the second parameter-page you can select the single-sounds directly. Reaching
the last sound of a group and going on automatically swaps to the next group.
<3>
Part\13\_303Lead
<3>\Mode:\\\\\On
With this parameter you decide how a sound is played. The both monophonic
modes allow the use of portamento. They simulate the single-trigger playing like
the old analog synth of former days. The envelopes are triggered only if the
previous key is released. The following modes are available:
Mode: OFF- the part is disabled
Mode ON- the selected part can be played polyphonic.
Mode: MONO- the part can be played only monophonic. The highest note has
priority when pressing more than one key.
Mode: LEAD- the part can be played only monophonic. The last note has priority
when pressing more than one key.
<4>
Part\13\_303Lead
<4>\Level:\\\127
With this parameter you can regulate the volume of the chosen part.
<5>
Part\13\_303Lead
<5>\Panorama:___
With this parameter the part can be placed in panorama. The different types and
effects of the panorama are shown later on this page.
<6>
Part\13\_303Lead
<6>\FX1-Send:\\0
The send-level of the part-signal that is sent to the effect processor 1 (FX1) can be
selected in this menu.
<7>
Part\13\_303Lead
<7>\FX2-Send:\63
The send-level of the part-signal that is sent to the effect processor 2 (FX2) can be
selected in this menu.
<8>
Part\13\_303Lead
<8>\CoarseT:\-12
Each part can be tuned individually. Here you can change the coarse-tune in
semi-tones.
<9>
Part\13\_303Lead
<9>\FineTune:\+0
Each part can be tuned individually. Here you can change the fine-tune e.g. for
detune-effects between two simultaneously playing parts to make a sound more
fat. Warm and full sounds are the result.
Here you see the different panorama-positions and effects, which Technox offers in the part-edit menu.
Panorama:---
At this value, the signal can only pass the output through the FX-processors.
Panorama:L<7-R>7
Different absolute positions are selectable between left and right.
Panorama:RND
Random-Panorama - every new note has another pan-position
Panorama:key\or\yek
The pan-position is controlled by the keynumber of the played note.
Panorama:dyn\or\nyd
The pan-position is controlled by the dynamics (Key-velocity)
To Next Page
Loading...
Need help?
General
