Quasimidi Technox User Manual

21
10.a.) Storing a
performance
PERFORMANCE-EDITING/STORING A PERFORMANCE
5.) Use the „VALUE/SOUND“ dial to select performance-mode.
Edit System
|1> Mode:Perform
6.) After the termination of steps 1 to 5, the Edit-System-Menu can be quitted.
(Texte Tabelle 1/21)
Because the TECHNOX is capable of storing several different parameter changes from different edit-menus, it’s useful to
list all parameters here for a second time. We also give you a reference to the corresponding sections in the manual where
you can find a detailed description of these parameters. For each performance the following parameters can be memorized:
1
The total amount of single-sounds to be used by a performance (Single, Layer 1 to Layer 4) and the main volume
of this performance. (see „Common Menu“, pg. 22 ff.)
2
All effect parameters of the performance (see „Effect editing“, pg. 12 ff.)
3
All part-parameters for part #13 to #16. These parts are used by a performance. (see „Single-Sound-Editing“, pg.
9 ff.)
4
Arpeggiator parameters. (see „Editing the arpeggiator“, pg. 25 ff.)
5
Settings within the „Common Menu“. In this menu it is possible to route the different MIDI controllers such as
Modulation, Pitch bend, Aftertouch as well as a user-defined MIDI controller to the different sound parameters.
(see „Common Parameters“, pg. 22 ff.)
After finishing performance editing, the performance will be saved like follows:
Function User action /
(Keys/Dials)
Display-Message
Select „Write/Dump“ menu. 1.) Press „EDIT/OK“ key.
2.) Use one of the two Alpha-dials to
select the „Write/Dump“ menu.
\Edit/Function
<8>\Write/Dump..
Activate sub-menu „Write
performance“.
1.) Press „EDIT/OK“ key.
2.) Use „PARAMETER/
SOUNDGROUP“ dial to select the
„Write performance“ sub-menu.
|1>\Write\Perf.?
Yes<OK>\No<EXIT>
Start saving performance. Press „EDIT/OK“ key.
Name:\Slidox
Yes<OK>\No<EXIT>
Enter new name. Move cursor with
„PARAMETER/SOUNDGROUP“
dial; select letter with
„VALUE/SOUND“ dial.
Name:\My_Perf
Yes<OK>\No<EXIT>
Confirm new name and select
memory position where the
performance shall be stored.
Press „EDIT/OK“ key and select
memory position with
„VALUE/SOUND“ dial.
to\22\<Soloist•>
Yes<OK>\No<EXIT>
Complete storage of the
performance.
Press „EDIT/OK“ key
Overwr\Soloist•?
Yes<OK>\No<EXIT>
Overwrite old performance. Press „EDIT/OK“ key
|1>\Write\Perf.?
\\\\\\\\\\ok!
Quit „Write/Dump“ menu. Press „EXIT“ key until the main
page is displayed
\T_e_c_h_n_o__x
RAM-22:\MyPerf
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/

Quasimidi Technox Specifications

General

Brand	Quasimidi
Model	Technox
Category	Synthesizer
Language	English