Quasimidi Technox - Page 24

24
11.) The common-menu
The last two parameters are only available in performance-mode. They affect the performance-type and
the general volume of the performance.
<30>
\\Edit\Common
<30>\Mode:Single
Up to four different sounds can be stacked to build up a performance. In this menu
you can select one of the following modes for your performance:
Single - 1 sound ( part 13)
Layer2 - 2 sound ( part 13-14)
Layer3 - 3 sound ( part 13-15)
Layer4 - 4 sound (part 14-16)
<31|
\\Edit\Common
<31|\Volume:\110
Here the general volume for the performance will be adjusted.
Perhaps you may have recognized „FX-2“ as a modulation target in the controller matrix. The following
table shows you which parameter of FX-2 can be changed with this controller:
At every algorithm of FX-2 you have one parameter, which allows
realtime control by the modulation matrix. Here you see, which
parameter is influenced in which algorithm, when you increase the
FX-2 depth in the modulation matrix.
1
|1>\01:Chorus1
Depth
2
|1>\02:Chorus2
Rate
3
|1>\03:Chorus3
Center
4
|1>\04:Flanger1
Rate
5
|1>\05:Flanger2
Center
6
|1>\06:Phaser1
Rate
7
|1>\07:Phaser
Center
8
|1>\08:Panning
Manual Pan
9
|1>\ShortDely
Feedback
10
|1>\LongDelay
Feedback
11
|1>\HQ-Delay
Feedback
12
|1>\Ping-Pong
Feedback
13
|1>\GatedDely
Feedback
14
|1>\SpecialFX
Center
15
|1>\Equalizr1
Output Level
16
|1>\Equalizr2
Output Level
17
|1>\WahWah+Ov
Fequenz
18
|1>\AutoWhaWa
Drive
19
|1>\WarmOvdrv
Input Level
20
|1>\Distortn
Input Level
21
|1>\no\Effect
Serial-Feed-Level => FX-1
realtime-control
of FX-2
parameters
performance-
parameter
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/