Quasimidi Technox User Manual

28
14.) The Edit-System-Menu
<5>
\\Edit\System
<5>\VelCrv:\Exp+
Here you can select the velocity curve; i.e. the response characteristics of your
TECHNOX in reference to the incoming MIDI note-on velocities. Refer to the
table below for detailed description of the different velocity curves.
<6>
\\Edit\System
<6>\RxPrgChg:\ON
This parameter sets the reception of program change information to on or off.
<7>
\\Edit\System
<7>\RxSetupC:OFF
If set to „ON“, incoming program change messages will be interpreted as „Setup“
changes. The setup change information has to be sent on the basic channel (see
above); the part that lies on this channel won’t respond to program change
informations.
<8>
\\Edit\System
<8>\RxTouch:\\ON
This parameter sets the reception of Aftertouch information to on or off. Notice
that any Aftertouch informations will be omitted, even if enabled within the
modulation matrix.
<9>
\\Edit\System
<9>\RxModul:\\ON
Here the reception of MIDI controller data will be enabled or disabled. Notice that
any controller informations will be omitted, even if enabled within the modulation
matrix.
<10>
\\Edit\System
<10>\RxParam:\\On
Enable or disables the reception of system-exclusive data.
<11>
\\Edit\System
<11>\TxParam:OFF
If set to „ON“, ‘real time’ parameter changes (via the „VALUE/SOUND“ Alpha
dial) will be sent via MIDI Out of your TECHNOX. This enables a sequencer to
record these parameter changes (for example Filter cutoff, envelope offsets, etc.)
<12>
\\Edit\System
<12>\TxFoot:\OFF
If this function is enabled, control change information (of footswitch controller)
will be sent out via MIDI.
<13>
\\Edit\System
<13>\TxClock:OFF
This enables or disables the sending of MIDI clock data if the arpeggiator is in use.
This allows the TECHNOX to control the tempo of other slave devices (such as
sequencers, drum-machines, etc.)
<14>
\\Edit\System
<14>\OmniMod:\On
If Omni-mode is set to „ON“, the TECHNOX will receive MIDI data on all 16
channels; but it’ll work only in performance mode. Usually you won’t need to use
the Omni mode anyway... When in sequencer mode, this parameter won’t appear
because the TECHNOX will then work only in MIDI Multi mode.
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/

Quasimidi Technox Specifications

General

Brand	Quasimidi
Model	Technox
Category	Synthesizer
Language	English