What to do if Quattroflow QF1200 stopped by the thermal circuit breaker?
If your Quattroflow Water Pump has stopped due to the thermal circuit breaker, allow the motor to cool down and consider reducing the power consumption.
Why Quattroflow QF1200 does not start?
There are several reasons why your Quattroflow Water Pump might not be starting: * Check the power supply and cables. * Ensure the front screws of the pump chamber/pressure plate are tightened to the defined torque. * Verify suction pipeline and TC-seals for tightness. * Confirm the correct flow direction as indicated by the arrow on the pump; if incorrect, turn the pump head. * Make sure that there are no foreign bodies in pump. * The diameters of the pipes in suction or pressure line are too small, which poses a risk for cavitation. * Check viscosity of liquid pumped. * Avoid air inclusions in the liquid to be pumped. * Open valve in discharge line completely, remove obstruction in discharge line to check pressure head. * Check the coupling halves, they must be fixed...
What to do if Quattroflow QF1200 does not start?
If your Quattroflow Water Pump isn't starting, consider these potential causes and solutions: * The bearings might be worn or defective and must be replaced. * The valves could be dry, deformed, or worn; change the valve or wet the pump. * The diaphragm might be burst; replace it with the respective elastomer service-kit. * Defective O–rings between valve plate and pump housing; replace them with the respective elastomer service-kit. * The clamping ring screw got loose; fix it with the defined torque. * The parameters of the control panel are wrong; check basic settings. * Pump may not start in manual mode if configured for remote operation, so check parameter settings. * If the pump cooled down too fast after SIP, allow slow cooling with room temperature. * Check chemic...
General| Brand | Quattroflow |
|---|---|
| Model | QF1200 |
| Category | Water Pump |
| Language | English |
To Next Page