EN.
27
7.2. Installing the Qubino Temperature Sensor
The temperature sensor is a Qubino accessory and is sold separately - for more info, please see
the Qubino product catalogue or website: http://qubino.com/products/accessories/
Product ordering code: ZMNHEA1
Qubino Z-Wave devices have the option to connect a temperature sensor (sold separately), which
allows you to remotely monitor ambient or water temperature. Qubino devices are the only Z-
Wave devices of its kind to offer this unique capability. With the sensor connected to the device,
you can carry out accurate measurements of room temperature, pool water temperature, etc.
and build automation rules around them. Qubino device with a temperature sensor is connected
directly to power supply. Install it and forget it, there is no need to worry about changing the
batteries like with most other Z-Wave temperature sensors which run on batteries. The
temperature sensor’s range is between -25 ~ +80°C (-13~ 176°F), resolution 0.1°C.
For more details about the temperature range, see the manual for the temperature sensor
below.
Qubino_Temperature Sensor:
https://qubino.com/manuals/Installation/Temperature_Sensor_manual.pdf
The digital Temperature sensor comes with a 1 m (3.3 ft) cord and a connector to attach it
directly to a Qubino device.
1. To prevent electrical shock, make sure that no voltage is present on the temperature
sensor cable.
2. When connected to Qubino device, the temperature sensor is under high voltage, which
is very dangerous.
3. Goap d.o.o. does not take responsibility for any damage or electrical shock due to
incorrect sensor assembly.
4. The above instructions and description apply to a temperature sensor compatible with
Qubino products only.
To Next Page
Loading...