EN.
57
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V2
NOTE: The above list is valid for the product with a temperature sensor connected to TS terminal
at the time of inclusion. In case the sensor is not connected then the following command class
and endpoint 3 are not supported:
COMMAND_CLASS_SENSOR_MULTILEVEL_V7
Endpoint 2 is supported by the module only when the parameter no. 71 is set to the value 1 and
the module is excluded and re-included into the network.
This product can be included and operated in any Z-Wave network with other Z-Wave certified
devices from any other manufacturers. All constantly powered nodes in the same network will
act as repeaters regardless of the vendor in order to increase reliability of the network.
COMMAND_CLASS_METER
• Default values:
o Rate Type = 1 (Import)
o Scale = 0 (kWh)
To Next Page
Loading...