Queclink QLM100 User Manual

QLM100 User Manual
TRACQLM100UM001 - 13 -
key. Note: The Force_USB should be on switch to the side as the Figure5 shows.
Figure 5. Power on the module
3.3. Send command by the USB
Connect the EVB with micro USB cable interface to send command to module.
Step1. Install USB driver " qud.win.1.1_installer_10065.1" on your PC.
Step2. Power on the device.
Step3. Connect the USB, you will find the two COM port on PC management, select the
one except "Qualcomm HS-USB MDM Diagnostics 90B2" on QCOM tool.
Quec
Figure 5igure 5
..
Power P
Send command by
Send comman
the E
Confidential
ule
o USB cable interface to send comable interface to send c
iver " qud.win.1.1_installer_10065d.win.1.1_installer_10065
on the device. e.
onnect the USB, you will find the onnect the USB, you will find t
e except "Qualcomm HS-USB MD
xcept "Qualcomm HS-USB M
VeryPDF Software Demo Version (http://www.verypdf.com)
VeryPDF Software Demo Version (http://www.verypdf.com)

Queclink QLM100 Specifications

General

Brand	Queclink
Model	QLM100
Category	Network Hardware
Language	English