Need help?Do you have a question about the Quectel EC200S Series and is the answer not in the manual?
Details AT commands like AT+CGDCONT and ATD*99# for initiating PPP connection, based on RFC 1661.
Flowchart for power-on, network registration, APN setup, and connection negotiation.
Explains module communication modes via USB/UART and switching between data and command modes.
Describes how to handle Unsolicited Result Codes (URC) for calls/messages in data mode.
Explains DCD pin functionality and its control via AT&C command for carrier status.
Outlines essential steps: SIM card activation and network registration before PPP connection.
Guides through modem configuration, creating a dial-up connection, and establishing the connection.
General| Module Type | LTE Cat 1 Module |
|---|---|
| Form Factor | LCC |
| Frequency Bands (LTE TDD) | B38/B40/B41 |
| Frequency Bands (GSM) | 850/900/1800/1900 MHz |
| Data Rate (LTE DL) | 10 Mbps |
| Data Rate (LTE UL) | 5 Mbps |
| Data Rate (GPRS DL/UL) | 85.6 kbps |
| Data Rate (EDGE DL/UL) | 236.8 kbps |
| Power Supply | 3.4V to 4.2V |
| Operating Temperature | -40°C to +85°C |
| GNSS | Optional |
| SIM Interface | 1.8V/3.0V |
| Technology | LTE, GSM |
| Frequency Bands (LTE FDD) | B1/B3/B5/B8 |
| Interface | UART |
| Storage Temperature | -45°C to +90°C |
| Certifications | CE, FCC |
To Next Page
