Need help?Do you have a question about the Quectel EC200 Series and is the answer not in the manual?
General| Series | EC200 |
|---|---|
| Technology | LTE Cat 1 |
| GNSS | GPS/GLONASS/BeiDou/Galileo/QZSS |
| Frequency Bands | LTE: B1/B3/B5/B8 |
| Data Rate | LTE Cat 1: 10 Mbps DL / 5 Mbps UL |
| Interface | USB 2.0, UART, SPI |
| Operating Temperature | -40°C ~ +85°C |
| Certifications | CE, FCC, PTCRB, GCF |
Details general procedures for PPP setting using AT commands, including APN configuration.
Provides a flowchart of recommended steps for PPP setting and network registration.
Explains the two operating modes (data and command) for USB/UART ports and how to switch between them.
Describes handling Unsolicited Result Codes (URCs) for calls/messages while in data mode.
Details the Data Carrier Detection (DCD) mode configuration using AT&C command.
Outlines essential preparation steps, including SIM card registration, before PPP dial-up.
Instructions for adding and configuring the modem driver and its properties in Windows.
Steps to create and configure a new dial-up network connection in Windows.
To Next Page
