SQ11 mini DV. User Guide.
| Home | User Manual | SQ11 |
Q7 SQ8 SQ9 SQ10 SQ12
Operating Instructions
SQ11
Charging
Attention! Before using for the
first time, fully charge the mini
camera battery!
This mini video camera has a
built-in lithium-ion battery. You can perform charging in one of the
following ways:
1. Connect the mini video camera to the USB port of your PC, stop
recording first.
2. Connect the mini camera to a charger from a 220V network or a
portable 5V charger. In this case, you can continue to use the mini-
camera in the charging process. In the charging process, the blue
and red LEDs will light constantly.
After the mini camera battery is fully charged, the blue LED will light
constantly and the red LED will turn off.
• If the built-in battery is empty or there is not enough space on the
memory card to continue, the blue and red LEDs on the mini
camcorder will blink for 5 seconds simultaneously, after which the
mini camcorder will save the recorded video and automatically turn
off.
• If the memory card is not installed, the blue and red LEDs of the
Mini Recorder will blink simultaneously for 5 seconds, after which the
Mini Camera will automatically turn off.
• If the camcorder is in the standby mode and does not take any
action on it, the camcorder automatically turns off after 1 minute to
save the charge of the built-in battery.
To Next Page
General