What to do when Quell Q4000DCS-WCB has a low battery?
If your Quell Smoke Alarm displays a low battery warning, promptly remove the unit, discharge it, and dispose of it properly. Replace it with a new alarm as soon as possible to maintain uninterrupted protection.
What to do if there is a network error with my Quell Q4000DCS-WCB?
In the event of a network error with your Quell Smoke Alarm, you can try the following: * Silence the alarm for 24 hours by pushing/releasing the Test/Hush button once. * Push and hold the Test/Hush button until you hear two beeps (approximately 4 seconds), then release to attempt to rejoin the network. * If the error continues, remove, discharge, and replace the alarm as soon as possible. * When the Test/Hush button is pushed/released once, the red LED will blink out an error code (number of blinks). Report the number of blinks to customer service if needed.
What to do if my Quell Smoke Alarm signals the end of its life?
If your Quell Smoke Alarm is beeping due to the end of its unit life, you can temporarily silence it by pushing/releasing the Test/Hush button. However, you should remove, discharge, and dispose of the unit, and replace it as soon as possible.
What to do after the Quell Q4000DCS-WCB Smoke Alarm enters End of Unit Life Hush Mode?
If your Quell Smoke Alarm is beeping due to the end of its unit life after pushing the Test/Hush button, you should remove, discharge, and dispose of the unit, and replace it as soon as possible.
What to do if my Quell Q4000DCS-WCB is in fault mode?
If your Quell Smoke Alarm is in fault mode, try the following: 1. Refer to the Cleaning Your Alarm section. 2. Attempt to reset the unit by pushing the Test/Hush button once. 3. When the Test/Hush button is pushed/released once, the red LED will blink out an error code (number of blinks). Report the number of blinks to customer service if needed.
What to do if Quell Q4000DCS-WCB is in End of Life Hush Mode?
If your Quell Smoke Alarm enters End of Life Hush Mode after you push/release the Test/Hush button, you should remove, discharge, and dispose of the unit, then replace it as soon as possible.
What to do if Quell Q4000DCS-WCB is in fault mode?
If your Quell Smoke Alarm is in fault mode, attempt to reset the unit by pushing the Test/Hush button once. Refer to the Cleaning Your Alarm section. If needed, report the number of flashes to customer service.
Guide to creating an interconnected wireless alarm network using intelligent self-enrollment and voice prompts.
Steps for easily adding new units to an existing wireless alarm network, modifying it user-friendly.
Procedure to reset a device's wireless settings if issues arise during network setup, following specific directions.
General| Model | Q4000DCS-WCB |
|---|---|
| Sensor Type | Photoelectric |
| Alarm Volume | 85 dB |
| Power Source | Battery |
| Hush Feature | Yes |
| Color | White |
| Compliance | UL 217 |
| Alarm Type | Smoke |
| Battery Type | 9V Alkaline |
| Interconnectability | Yes |
| Features | Test button |
To Next Page
