Need help?Do you have a question about the Quick BTQ140 and is the answer not in the manual?
General| Brand | Quick |
|---|---|
| Model | BTQ140 |
| Category | Outboard Motor |
| Language | English |
Covers requirements for tunnel positioning and installation.
Details tunnel end shapes, water flow resistance, and grating for waterline tunnels.
Explains thruster installation angle and positioning within the tunnel.
Instructions for using the flange to mark holes and ensure precise alignment.
Details fitting the gearleg, seal gasket, silicone application, and motor attachment.
Guide for installing propellers, drive pins, nuts, anodes, and final propeller positioning check.
Refers to separate manuals for control panel installation.
Covers warnings about continuous use, bypassing protections, swimmers, flammables, and operation out of water.
Notes on propeller installation on the right-hand side of the gearleg for single and double propellers.
Explains that start-up follows TCD panel activation and refers to TCD manual.
Lists annual tasks: cleaning, anode replacement, propeller check, screw tightness, and battery check.
Warns against painting anodes, sealing, and gearleg shafts where propellers are lodged.
Provides dimensions A, B, C for BTQ140 single propeller models.
Provides dimensions A, B, C for BTQ185 single propeller models.
Provides dimensions A, B, C for BTQ185 double propeller models.
To Next Page
