23
GB
BOW THRUSTER BTQ250 - BTQ300 IT GB - REV002A
WARNING
WARNING: make sure no swimmers or fl oating objects are in the vicinity before switching on the thruster.
NOTE: The motor-reversing solenoid group is pre-assembled and wired in such a way that the direction of
the propeller thrust corresponds to the command indication stamped on the control panel TCD10xx only if
the propeller LH is fi tted on the port side of the boat and the propeller RH is fi tted on the starboard side (see
drawing on page 19). If the propeller is fi tted otherwise, all that must be done is to invert the connection of the
two cables (blue and grey) of the control cable (n° 29 on the exploded drawing BTQ25 on pages 24/25 or n° 30 of
the exploded drawing BTQ30 on pages 26/27).
USE OF THE BOW THRUSTER
Information from the “TCD1022 and TCD1042” manual.
QUICK
®
RESERVES THE RIGHT TO INTRODUCE CHANGES TO THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
USAGE
F
To Next Page
Loading...
Need help?
General
