18
TCD 2044
EN
INSTALLATION AND USE MANUAL - REV 002A
2.0 - INSTALLATION
2.2 - Control installation
GUARNIZIONE
ADESIVA
5
8
6
7
4
• Clean the surface before installation.
•
4
- Detach the protective paper from the gasket taking
care not to touch the adhesive side with your fingers.
ADHESIVE
GASKET
TRANSPARENT
PROTECTIVE FILM
ADHESIVE
POLYCARBONATE
•
5
- Insert the control into the hole and press it to make
it adhere well to the surface. Tighten the four self-
tapping screws provided to secure it to the panel.
• Use M3 countersunk screws (not supplied) to fix the
device on metal sheet.
• Clean the surface of the control before application.
•
6
- Remove the protective paper from the back of the
label. For a better seal, avoid touching the adhesive part
with your fingers.
•
7
- Apply the adhesive from above.
Press the entire surface firmly to make it stick well.
•
8
- At the end of installation, remove the transparent
protective film from the control surface.
• It is recommended to use a piece of adhesive tape to
remove the transparent film.
WARNING
It is recommended not to apply
the
adhesives (gasket and polycarbonate)
at a temperature below
18° C
.
18°
To Next Page
Loading...
