23
TCD 2044
EN
INSTALLATION AND USE MANUAL - REV 002A
3.0 - OPERATION
3.6 - Disabling the control
The control is disabled in the following cases:
• When the enabling button is pressed.
• When there are several controls in parallel and another is activated.
• When 6 minutes have elapsed since activation without performing any operation or since the last time the joystick was
moved.
Passage to the disabled state is signalled by the control with a prolonged sound of around one second and the following
slow flashing of the enabling LEDs.
3.7 - Multiple controls in parallel
Several TCD series controls can be installed in parallel. In this case, it is possible to operate only one control at a time. The
active control is always the last one to be activated; the other parallel controls are automatically disabled.
When a thruster is commanded by the last control enabled, the boat movement direction will be indicated by the relative
LED which will light up also on the other disabled controls.
3.8 - Disabling/enabling the control sound
The acoustic signals emitted by the control can be disabled.
Carry out the following procedure:
• Remove power to the control.
• Keep the enabling key pressed and supply power to the control which will emit a short sound.
• Release the enabling key and wait for the control to test the LEDs and be disabled (slow flashing of the enabling LEDs).
The acoustic signals emitted by the control can be re-enabled.
Carry out the following procedure:
• Remove power to the control.
• Keep the enabling key pressed and supply power to the control which will emit two short sounds.
• Release the enabling key and wait for the control to test the LEDs and be disabled (slow flashing of the enabling LEDs).
To Next Page
Loading...
Need help?
General
