Quick XR Series - Chains and tightening torques; Supply and equipment; Standard supply and material included in the package; Quick accessories required, not included in standard supply

XRSeries
EN
XRSeries
QUICK XRSeries INSTALLATION AND USER’S MANUAL - REV000A
7
1 - Information about the product
1.4 - Chains and tightening torques
XR7
GYPSY 14 mm 16 mm 18 mm 12.5 mm 14 mm 16 mm
SUPPORTED
CHAIN
14 mm 14 mm 16 mm 16 mm 18 mm 18mm 12.5 mm 14 mm 16 mm
DIN 766 ISO(**) DIN 766 ISO(**) DIN 766 ISO(**) STUD-LINK STUD-LINK STUD-LINK
(**) ISO EN 818-3.
XR8
GYPSY 16 mm 19 mm 20.5 mm 22 mm
SUPPORTED
CHAIN
16 mm 17.5 mm 19 mm 20.5 mm 22 mm
STUD-LINK STUD-LINK STUD-LINK STUD-LINK
XR9
GYPSY 22 mm 24 mm 26 mm
SUPPORTED
CHAIN
22 mm 24 mm 26 mm
STUDLINK STUDLINK STUDLINK
XR7 XR8 XR9
TIGHTENING TORQUE
Nm
M6 6.5
M8 16
M10 31
M12 55
M14 87
M16 135
Indicative values for stainless steel screws, consider tightening by
evaluating the material of the surface where it will be fastened.
2 - Supply and equipment
2.0 - Standard supply and material included in the package
• Windlass (top + gearmotor)
• Contactor or reversing contactor box (DC model only)
• Lever
• Screws for assembly
• Installation and user’s manual, Warranty
• Drilling template
2.1 - Quick
®
accessories required, not included in standard supply
• RH/LH chain pipe
• Band brake handwheel
2.2 - Tools required for installation
XR7 • Drill with bit: Ø 15 mm (19/32”) • Hole saw Ø 200 mm (7” 7/8) • Hex wrench: 17 and 19 mm
XR8 • Drill with bit: Ø 15 mm (19/32”) • Hole saw Ø 250 mm (9” 27/32) • Hex wrench: 17 and 19 mm
XR9 • Drill with bit: Ø 18 mm (45/64”) • Hole saw Ø 340 mm (13” 25/64) • Hex wrench: 24 mm
2.3 - Recommended Quick
®
accessories not included
• EC - BOX Electrical connection box for AC motors (XR7/XR8)
• Inverter
• Control from control board
• Waterproof push-button panel
• Foot-operated switch
• Control system via RRC radio
• Chain stopper