QuickJack 5000TL - Page 35

QuickJack™ Portable Car Jack 35 P/N 5900263 — Rev. B6 —September 2023
15. With the QuickJack engaged on the First Locking Position, check all Hydraulic Hose connections
for leaks. If you find any, tighten the leaking connection and wipe up the fluid.
If the Power Unit Motor becomes hot or sounds irregular, check the Power Unit and all electrical
connections.
16. Carefully rock the Vehicle to test its stability on the QuickJack.
If the Vehicle is stable, the QuickJack is ready for normal operation.
If the Vehicle is not stable, lower it to the ground and check the positioning of the Lift Blocks in the
Receiver Trays.
17. If everything appears to be working normally, lower the QuickJack Frames back down to the
ground.
18. To lower the vehicle: press the Up button for a second or two until the Lock Bars move past
the Lock Blocks, then press Down until the Lock Bars lower past the Lock Blocks.
When the Frames get to the ground, hold Down for another ≈5 seconds to allow the Hydraulic
Fluid to return to the reservoir and relieve the pressure in the hydraulic hoses.
Leave the Manual with the Owner/Operator
Make sure to leave this Setup and Operation Manual with the owner/operator so that it is available to
everyone who is going to use the QuickJack.
Setup
23
Checklist