93
Italiano
Deutsch
English
• If operating defects, faulty parts are found, or the machine does not function,
switch it off and disconnect the electric power supply: do not try to repair the
machine. All repairs are to be carried out by a specialised Quick Mill
technician. Contact Quick Mill Service Department.
The exchangers are fitted with thermal protection that stops the heating in the
case of failure or overheating.
All parts for heating and with electrical voltage are located inside the machine
panelling.
Specific instructions for maintenance staff:
• Access to maintenance areas is only permitted using the access keys
supplied with the equipment.
• If stored for long periods at temperatures below 2° C, the equipment hydraulic
circuit has to be emptied. Do not switch on the machine before reconditioning
it for at least an hour in a place with an appropriate environment temperature.
• Method and frequency of cleaning are indicated in the "MACHINE
CLEANING" section
• The equivalent weighted acoustic pressure level is less than 70 dB.
To Next Page
Loading...