Rev
1.0
Page
3
of
4
Operation
1. Power on the Hub:
Switch on power to the hub, the Power indicator on the hub will be on, and other three indicators will stay off. Press the “Test” button to change fan speed,
the fan will run in the following cycles:
1 speed fan: on -> off -> on -> off,
2 speed fan: high speed -> low speed -> off -> high speed -> low speed -> off
3 speed fan: high speed -> medium speed -> low speed -> off -> high speed -> medium speed -> low speed -> off
And, the Test indicator will blink as follows:
Low speed on: the speed LED will blink once every 2 seconds,
Medium speed on: the speed LED will blink twice every 2 seconds, and
High speed on: the speed LED will blink three times every 2 seconds.
2. Pairing the Hub with the In-Wall Switch:
2.1 Press and hold the “Pair” button, the “Pair” LED will be on for three seconds then turn off. All previous pairing info is removed (one hub can be paired
with 20 in-wall switches respectively).
2.2 Press the “Pair” button twice, the “Pair” LED will have one blink every second, and the hub is in paring mode (all the buttons on the hub are disabled).
2.3 Press either one of the two buttons on the in-wall switch to be paired, the “Pair” LED will be off, indicating pairing is successfully done. At this time,
the paired in-wall switch will display the current status of the hub (Please see “In-Wall Switch LEDs” for more details). Note: If there is no button press on
in-wall switch within 3 minutes, the hub’s “Pair” indicator will go off too, but pairing is incomplete. In this case, the user would need to go back to step 2.2
3. Sleep Mode of In-Wall Switch:
The wall switch will enter sleep mode whenever there is no button operation for 10s. Pressing either button can wake up the switch and display the current
hub status (corresponding timer indicator and speed indicator will be on).
4. LED Indicators of In-Wall Switch
Since the hub is usually installed in the attic and is not readily accessible, the in-wall switch will display the fans current operation status. The LED indicators
on the in-wall switch are used to display the fans current operation status, in addition to their regular functions. Fig. 6 shows the front of the in-wall switch.
4.1 For the first time when the hub is connected to the in-wall switch, all the timer LEDs are off and all the speed LEDs are blinking after pressing either
button in sleep mode. Press either button again to enter normal operation.
4.2 If there is no LED on within 3 seconds and all the LEDs are on after three seconds after pressing either button in sleep mode, the in-wall switch fails
to connect to the hub. Please press either button on the in-wall switch again to re-establish connection. If the connection link keeps failing, both the in-wall
switch and the hub need to be troubleshot ( check in-wall switch battery, hub wiring etc.)
4.3 If all the timer LEDs are off and only one of the speed LEDs is on after pressing either button in sleep mode, the hub is not running the motor at any
speed. Only after timer is set, the hub will run the motor at the set speed and the timer will start count-down.
To Next Page
Loading...
General