Page 9
Cold Start Procedure (Gasoline Engine Units)
• Release any remaining tank pressure by slowly opening the manual drain valve.
• Turn on the engine gasoline supply.
• Put the choke in the “On” position.
• Close the service valve and put Unloader lever in the “unload” (A) position for Honda engine
driven models.
• Start the engine, release the choke, and allow the engine to warm up for two to three minutes.
• Return the unloader lever to the “load” (B) position on Honda driven models.
DO NOT OPERATE GASOLINE ENGINE UNITS IN AN ENCLOSED AREA.
WARNING
NOTE: Turn the gasoline supply o when the compressor is not being used.
To Next Page
Loading...
